Description: CR Motor out of step
During CR Motor operation, there may be a case where the encoder pulse signal within the specified range is not input within a specified period of time or the pulse width is extremely long or short. In such a case, the CR Motor is judged to be out-of-step, so that this message is displayed and the printer stops operating.
Causes: • Defective CR Motor. • CR Motor driver damage (42V system short) • Broken temperature fuse for Cutter Solenoid.
Remedy: 1. Check to see if the CR Scale for detection of the encoder pulse is removed 2. Check for dirt, paper dust or damage to the CR Scale. 3. Perform the CR Timing Belt Tension Adjustment 4. Replace the CR Encoder Sensor 5. Replace the CR_HP Sensor 6. Replace the Motor Assy., CR 7. Replace the C593 MAIN Board 8. Replace the Cutter Solenoid.
Code: 00010006
Description: CR Motor over current
During CR Motor operation, there may be a case where an abnormal current out of the specified limits is detected in the CR Motor drive circuit on the C511 MAIN Board or a current exceeding the specified value is required. In such a case, this message is displayed and the printer stops operating.
Causes:
Remedy: 1. Check for dirt, paper dust or damage to the CR Scale. 2. Perform the CR Timing Belt Tension Adjustment 3. Replace the CR_HP Sensor 4. Replace the Motor Assy., CR 5. Replace the C593 MAIN Board
Code: 00010007
Description: CR Motor in-position time-out
At Carriage Unit stop processing in CR Motor control, there may be a case where the Carriage Unit can not move to the final target position within a specified period of time (as per pulse detection). In such a case, this message is displayed and the printer stops operating.
Causes: There are pulses smaller than out-of-step pulse remaining without completing paper feed.
Remedy: 1. Check to see if the CR Scale for detection of the encoder pulse is removed. 2. Check for dirt, paper dust or damage to the CR Scale. 3. Perform the CR Timing Belt Tension Adjustment 4. Replace the CR Encoder Sensor 5. Replace the CR_HP Sensor 6. Replace the Motor Assy., CR 7. Replace the C593 MAIN Board
Code: 00010008
Description: Servo interrupt watchdog time-out
During the CR Motor or PF Motor operation, there may be a case where watch dog time-out is detected in the DC motor control circuit or on the ASIC. In such a case, this message is displayed and the printer stops operating.
Causes:
Remedy: Since the cause is deemed to be a defective CPU or ASIC, replace the C593 MAIN Board .
Code: 00010009
Description: System interrupt watchdog time-out
In the data processing stage on the C511 MAIN Board, there may be a case where runaway or defective cash occurs on CPU or ASIC. In such a case, this message is displayed and the printer stops operating.
Causes:
Remedy: If not cleared by turning the power OFF and back ON, the CPU or ASIC is deemed defective, so replace the C593 MAIN Board .
Code: 0001000A
Description: CR axis detection error
During initial operation at power on or during printing operation, there may be a case where the home position can not be detected at the home position detection timing or within a specified period of time. In such a case, this message is displayed and the printer stops operating.
Causes:
Remedy: 1. Check for dirt, paper dust or damage to the CR_HP Sensor. 2. Replace the CR_HP Sensor 3. Replace the C593 MAIN Board