PrintCopy.info service

Epson SC-P5070

Error Codes List page 1

  • Code: 0010
  • Description: Communication with the AID Board is not established.
    The voltage applied to the Flushing Box does not reach the specified level.
  • Causes: Connection failure of FFC or FFC is broken.
    Due to accumulated ink and such around the Flushing Box, the electric current is leaking.
    High voltage power module in the AID Board is broken.
  • Remedy: 1 Check the connection to the AID Board, and correct it if any failure found.
    2 Check around the Flushing Box, and remove accumulated ink or dust if any. (Through accumulated ink or dust, the electric current may leak.)
    3 Replace the IS Unit.
    4 Replace the AID Board.
  • Code: 01
  • Description: SpectroProofer uninstallation error
  • Causes: The SpectroProofer or the Backing is not installed correctly.
  • Remedy: 1. Turn the power off and re-install the SpectroProofer.
    2. Check the connection between the SpectroProofer and Main Board for disconnection and damage (Main Board side: CN2, CN7).
  • Code: 02
  • Description: Paper Eject Support uninstallation error
  • Causes: The Paper Eject Support is not installed correctly.
  • Remedy: Turn the power off and re-install the SpectroProofer and Paper Eject Support.
  • Code: 1101
  • Description: CR life error
  • Causes: The maintenance counter for the Ink Supply Tube exceeded the threshold value. (CR scan pass counter has reached the specified value (six million passes)).
  • Remedy: Replace the following parts and reset the counter of the CR Motor and the FFC, Ink Tubes and CR Pads Counter.
    • Ink Tubes
    • CR Motor
    • Head FFC
    • Oil pad
  • Code: 1125
  • Description: CR HP detection error
  • Causes: The CR Unit cannot track the Home position to set the CR origin.
    • False origin detection due to paper jam or the like
    • Misreading of CR Scale
    • CR Lock is damaged.
  • Remedy: 1. Check if the paper is jammed.
    2. Check if the CR Scale is read out properly . • Check if the CR Scale is damaged or contaminated.
    3. Check if the CR Lock functions normally.
    1. Re-install the CR Encoder.
    2. Clean the CR Scale with ethanol.
    3. Replace the CR Scale.
    4. Replace the IS Unit.
  • Code: 1138
  • Description: CR Motor over current error
  • Causes: 1. Connection failure of the CR Motor or the CR Encoder.
    2. Detects accumulatively more than the specified number of times that the electric current which flows when driving the motor is irregularly large.
    • Irregular load
    • CR Encoder failure
    • CR Motor failure
  • Remedy: 1. Check the following connection for disconnection and damage. • CR Encoder to SUB Board (CN102) • CR Motor to SUB-B Board (CN204)
    2. Carry out "Encoder Check" to check if the CR Encoder functions normally.
    3. Carry out "Motor Measurement Adjustment (CR Motor)" to check if CR Motor functions normally.
    1. Replace the CR Encoder.
    2. Replace the CR Motor.
    3. If the printer does not recover from the error, it may be caused by irregular load of the CR Mechanism. Replace the Printer Mechanism.
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us