PrintCopy.info service

Duplo DPM410

Error Codes List page 1

  • Code: E001
  • Description: • The main motor (M1) is defective. • The main PCB Unit is defective. • The encoder sensor (PS7) is defective.
  • Causes: • While the drum rotation signal is lit, the encoder sensor (PS7) cannot detect the edge for 1 second.
  • Code: E002
  • Description: • The elevator motor (M2) is defective. • The elevator top limit sensor (PS9) is defective. • The elevator bottom limit switch (MS6) is defective. - The main PCB Unit is defective. • The elevator operation is defective.
  • Causes: • The elevator does not reach the top limit for 30 seconds after the elevator motor (M2) up signal is lit. • The elevator does not reach the bottom limit for 30 seconds after the elevator motor (M2) down signal is lit.
  • Code: E003
  • Description: • The cutter motor is defective. • The cutter limit switch is defective. - The main PCB Unit is defective.
  • Causes: • The cutter does not reach the limit for 30 seconds after the cutter motor move signal is lit.
  • Code: E004
  • Description: • The lamp is defective. • The invertor unit is defective. • The CCD is defective. • Main PCB unit is defective.
  • Causes: • In the lamp lighting check, amount of light received by CCD does not reach regulation value. (Perform the lamp lighting check once only, with the power turned on.)
  • Code: E009
  • Description: • The main PCB Unit is defective • The thermal head substrate is defective. • The thermal head is defective.
  • Causes: • At start of mastermaking, thermal head drive voltage does not reach regulation value.
  • Code: E040
  • Description: • The master set sensor is defective. • The cord for master set sensor is unconnected. - The main PCB Unit is defective.
  • Causes: • The master set sensor signal is detected continually for 20 seconds after power is on.
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us