Description: Thermistor disconnection detection error
When disconnection is detected with connector for 30 sec continuously.
Remedy: 1. Check connection of the Connector (J2063/J2510/J214). 2. Replace the Film Unit. 3. Replace the Fixing Main Unit. 4. Replace the DC Controller PCB (UN2).
Code: E010-0001
Description: Unstable rotation of the Main Motor (M1)
Detection is executed every 100 msec after the start of motor rotation; however, the drive detection signal is absent for 2 sec.
Remedy: 1. Check connection of the Connector (J2002/J2255/J203). 2. Replace the Main Motor (M1). 3. Replace the DC Controller PCB (UN2).
Code: E010-0002
Description: Unstable rotation of the Main Motor (M1)
During motor rotation, detection is executed every 100 msec; however, the drive signal is absent 5 times in sequence.
Remedy: 1. Check connection of the Connector (J2002/J2255/J203). 2. Replace the Main Motor (M1). 3. Replace the DC Controller PCB (UN2).
Code: E014-0001
Description: Unstable rotation of the Fixing Motor (M2)
Detection is executed every 100 msec after the start of motor rotation; however, the drive detection signal is absent for 2 sec.
Remedy: 1. Check connection of the Connector (J2001/J203). 2. Replace the Fixing Motor (M2). 3. Replace the DC Controller PCB (UN2).
Code: E014-0002
Description: Unstable rotation of the Fixing Motor (M2)
During motor rotation, detection is executed every 100 msec; however, the drive signal is absent 5 times in sequence.
Remedy: 1. Check connection of the Connector (J2001/J203). 1. Replace the Fixing Motor (M2). 2. Replace the DC Controller PCB (UN2).
Code: E020-0000
Description: The path between the sub hopper and the developing assembly is clogged with toner.
The Developing Assembly Toner Sensor (S25) detects the absence of toner, while the Sub Hopper Toner Sensor (S26) detects the presence of toner. With the Developing Cylinder Clutch (CL3) turned on, the hopper feed screw motor (M16) is rotated for 1 sec intermittently 194 times; still, the Developing Assembly Toner Sensor (S25) does not detect the presence of toner. * Error occurs after the delivery if a paper in passage exists.
Remedy: 1. Check the rotation of hopper motor gear. (If rotating, false detection by the sensor is doubted. Feed the toner to the developing unit in service mode: COPIER > FUNCTION > INSTALL > TONER-S.) 2. Replace the Developing Assembly Toner Sensor (S25). 3. Replace the Sub Hopper Toner Sensor (S26). 4. Replace the DC Controller PCB (UN2).