PrintCopy.info service

Canon LaserSHOT LBP3108B

Error Codes List page 1

  • Code: E000
  • Description: Error in startup
  • Causes: - The detected temperature of the thermistor does not reach 35 deg C within approx. 1.5 sec of the heater being turned on. - The detected temperature of the thermistor is 100 deg C or lower in standby mode.
  • Remedy: - Check connectors on the fixing film unit. - Replace the fixing film unit. - Replace the engine controller PCB.
  • Code: E001
  • Description: Error in abnormally high temperature
  • Causes: The detected temperature of the thermistor is 220 deg C or higher 30 times consecutively.
  • Remedy: - Check connectors on the fixing film unit. - Replace the fixing film unit. - Replace the engine controller PCB.
  • Code: E003
  • Description: Error in abnormally low temperature
  • Causes: - After the heater is turned on, the detected temperature of the thermistor is 100 deg C or lower at the time of printing after reaching 50 deg C. - After the heater is turned on, the detected temperature of the thermistor is 55 deg C or lower at paper intervals or in cleaning mode after reaching 50 deg C.
  • Remedy: - Check connectors on the fixing film unit. - Replace the fixing film unit. - Replace the engine controller PCB.
  • Code: E004
  • Description: Error in fixing heater drive circuitry (For 200V machines only)
  • Causes: An abnormal frequency is detected on the fixing drive circuit within approx. 3.3 sec of the power being turned on.
  • Remedy: - Check connectors on the fixing film unit. - Replace the fixing film unit. - Replace the engine controller PCB.
  • Code: E100
  • Description: Error in Scanner Unit
  • Causes: - At startup of the scanner, /BDI signal cannot be detected within 0.1 sec after forced acceleration of the scanner motor. - At startup of the scanner during activation of the scanner motor, the motor rotation exceeds the range of specified value (98.3 to 102.1%). - After startup of the scanner is correctly completed, /BDI signal exceeds the specified cycle 10 times consecutively.
  • Remedy: Check connectors on the scanner unit - Replace the scanner unit. - Replace the engine controller PCB
  • Code: E196
  • Description: Error in DCON communication
  • Causes: An error in data communication occurs in the Main controller.
  • Remedy: - Replace the engine controller PCB
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us