Description: FAX control PWB system error Processing with the fax software was disabled due to a software problem.
Causes: FAX control PWB
Remedy: 1. Turn the main power swtch off and after 5 seconds, re-mount the FAX controller PWB, then turn power on. 2. Reinstall the fax software. 3. Replace the FAX control PWB.
Code: 0060
Description: Main/Engine PWB mismatch Unmatching engine and engine sub boards. Defective engine subboard
Causes: Main/Engine PWB
Remedy: 1. Turn the main power swtch off and after 5 seconds, then turn power on. 2. Replace the main/engine PWB.
Code: 0100
Description: Backup memory device error
Causes: EEPROM (Main/Engine PWB)
Remedy: 1. Turn the main power swtch off and after 5 seconds, then turn power on. 2. Check that the EEPROM on the main circuit PWB is peroperly installed on the main circuit PWB and, if not, re-install it. 3. Replace the main/engine PWB.
Code: 0120
Description: MAC address data error For data in which the MAC address is invalid.
Causes: EEPROM (Main/Engine PWB)
Remedy: 1. Turn the main power swtch off and after 5 seconds, then turn power on. 2. Check the MAC address on the network status page. 3. If it is blank, obtain an EEPROM with its MAC address written from the service support and install. 4. Replace the main/engine PWB.
Code: 0150
Description: Backup memory read/write error (main/engine PWB) No response is issued from the device in reading/writing for 5 ms or more and this problem is repeated 5 times successively. Mismatch of reading data from 2 locations occurs 8 times successively. Mismatch between writing data and reading data occurs 8 times successively.
Causes: EEPROM (Main/Engine PWB)
Remedy: 1. Turn the main power swtch off and after 5 seconds, then turn power on. 2. Check that the EEPROM is peroperly installed on the main/engine PWB and re-install it. 3. Replace the main/engine PWB. 4. Check the EEPROM and if the data are currupted, contact the service support.
Code: 0160
Description: Backup memory data error (main/engine PWB) Reading data from EEPROM is abnormal.
Causes: EEPROM
Remedy: 1. Turn the main power swtch off and after 5 seconds, then turn power on. 2. Execute U021 - memory initializing.(see page 1-3-19) 3. If the EEPROM data are currupted, contact the service support.