Ricoh SP5200DN

Error Code:

Code: 542
Description: Fusing temperature warm-up error
1: Thermistor detects that the rate of heat increase is less than 7 degrees per 2 seconds consecutively 5 times. 2: The fusing temperature did not reach the standby temperature within 24 seconds at the center of the hot roller after the main switch turned on. This SC will appear when condition 1 and 2 occur at the same time.
Causes: Defective thermistor. Thermistor improper installation. Defective fusing lamp
Remedy: • Install the thermistor properly. • Replace the thermistor. • Replace the fusing lamp. • This SC cannot be reset by turning the power off and on. • This SP should be reset by a CE. • SP5810-01 can reset this SC.

	Error Code
	Service Mode, Troubleshooting
	Parts Catalog
	Compatibility
	Downloads Files
	Home