PrintCopy.info service

Ricoh SP210

Error Codes List page 1

  • Code: SC100
  • Description: CIS Lamp/Scanner Motor Error (C6)
  • Causes: A problem occurred with the CIS or scanner motor in the flatbed scanner: • After CIS power check • After shading • After CIS failed to return to home position
  • Remedy: • Check the scanner harness connection • Replace the scanner
  • Code: SC202
  • Description: Polygon Motor On Timeout Error (C1)
  • Causes: No lock signal was received within 10 sec. after the polygon motor turned on.
  • Remedy: • Check the laser unit harness connection • Replace the laser unit
  • Code: SC203
  • Description: Polygon Motor Off Timeout Error (C2)
  • Causes: The lock signal did not go HIGH (inactive) within 20 sec. after the polygon motor turned off.
  • Remedy: • Check the laser unit harness connection • Replace the laser unit
  • Code: SC204
  • Description: Polygon Motor Lock Signal Error (C3)
  • Causes: Four samplings within 200 ms revealed that the polygon motor lock signal remained HIGH beyond the prescribed number of revolutions.
  • Remedy: • Check the laser unit harness connection • Replace the laser unit
  • Code: SC220
  • Description: Beam Synchronization Error (C4)
  • Causes: Top cover (or maintenance cover) is down and locked, and the polygon motor is locked, but laser synchronization could not be achieved within 40 msec.
  • Remedy: • Check the laser unit harness connection • Replace the laser unit
  • Code: SC268
  • Description: Laser Scanning Unit thermistor error (C0)
  • Causes: After the main power switch ON, writing thermistor temperature is detected at 100ms intervals an ... • Less than -30 degrees Celsius is detected for more than 4 seconds (Thermistor defective). • More than 105 degrees Celsius is detected for more than 1 second (Thermistor short).
  • Remedy: • Check the laser unit harness connection • Replace the laser unit
Service manual
Error Code
Parts Catalog
Compatibility
Home
New Register Forgot Password?
Send message to us