Causes: The system must be re-started after changing model size, PCB assembly type or other system parameters. This message appears to prompt the user to turn power OFF so the system can re-start.
Remedy: Turn power OFF immediately.
Code: n14
Display: <SET WINDING>
Description: Request for setting sheet in the winding unit
Causes: The sheet edge setting condition to the winding unit has been met at the origin renewal timing and the plotter is waiting for sheet setting.
Remedy: 1. If the sheet edge has not been set to the winder, press the < key to start sheet setting operation. 2. If the plotter was started with sheet set in the winder, press the > key to start winding operation.
Code: n15
Display: ROLL < (COUPLE)
Description: Sheet detection with the coupler enabled
Causes: The coupling option is available when the lever is lowered for sheet detection. This message indicates that only rear setting of the roll sheet is possible in tjhis condition.
Remedy: 1. This is not an error, so no action is needed. If you do not plan to use the coupler, switch it OFF to disable it. 2. If this message appears on a model without the coupler option, the main PCB assembly may have been taken from another model. If this is the case, simply reset the parameters with SETUP RESET in the SETUP menu.
Code: n16
Display: * * VIEW * *
Description: NR command received
Causes: A pause instruction of MGL_IIc was received and the plotter is in a pause.
Remedy: 1. Press the REMOTE key to cancel the pause unless resetting or other action is necessary. 2. Normally, this instruction is issued by the application for a specific reason. Follow the instructions in the application manual.
Code: n17
Display: * * DIGITIZE * *
Description: DP command received
Causes:
Remedy: A digitizing instruction of MGL_11C was received and the plotter is waiting for operation. The system is in Digitize Mode with jog keys enabled. Move the target point with the jog keys, then press the Enter/Hold key to enter that point. Normally, this instruction is issued by the application for a specific reason. Follow the instructions in the application manual. 1 byte of received data was lost. Since the digitizing instruction is represented by DP and the pen-down plotting instruction often has data format of PDPA~ or PDPR~, the system may very rarely be set to Digitize Mode depending on the timing of data loss. If this is the case, suspect abnormal line cut or missing cut. Troubleshoot in reference to Cause 5 under Error 10 Commands.
Code: n18
Display: * XXX/XXX COPY *
Description: Displayed during copy cutting
Causes: “No. COPIES” execution is in progress.
Remedy: This is not an error, so no action is needed.