Xerox WorkCentre 7655

This RAP is used when Skew, System Registration, or Magnification are out of specification.

Initial Actions

• Ensure that the paper being used is fresh, dry, and within specification.

Procedure

	Procedure	Yes	No
1	The problem occurs in the copy mode only.	8	2
2	The problem occurs in both the print and copy mode.	3	Go to Call Flow.
3	The original is positioned on the glass properly.	4	Position the original properly.
4	Check the DADF Drive Rolls and Pinch Rolls for wear and glossing. Check the Document Handler Adjustment ADJ 5.1, ADJ 5.2, ADJ 5.3, ADJ 5.4, ADJ 5.5, ADJ 5.6. The paper path is OK.	5	Clean and/or repair the paper path as required.
5	The defect occurs on copies from all five Paper Trays.	6	Adjust the IOT Lead Edge/Side Edge Registration (ADJ 9.7). Check the affected Feed Tray for wear, slipping, damage, and/or contamination.
6	Registration varies from copy to copy.	7	Go to BSD 5.15 - Copy/Scan Image Input Processing (1 of 3). Check that the connectors on the IIT/IPS PWB are seated and free of damage. If the problem continues, replace the IIT/IPS PWB (PL 13.8). If the problem persists, replace the Lens Assembly (PL 13.6).
7	Go to BSD 5.15 - Copy/Scan Image Input Processing (1 of 3). Check that the connectors on the IIT/IPS PWB are seated and free of damage. If the problem continues, replace the IIT/IPS PWB (PL 13.8). If the problem persists, replace the Lens Assembly (PL 13.6).
8	Replace the MCU PWB (PL 11.1). If the problem continues, replace the CCM PWB (PL 11.7).