Xerox WorkCentre 5335
Service Mode 09. Component Control
Purpose
The purpose of the Component Control is to display the logic state of input signals and to energize output components.
Procedure
- Enter Diagnostic Mode (Accessing UI Diagnostics).
- Press the Machine Status button on the Control Panel.
- Select the Tools tab on the UI screen.
- System Settings and Common Service Settings will be highlighted.
- In the Features column, select Maintenance / Diagnostics. Scroll to and select IO Check.
- Select Component Control.
- Input Chain-Link number, then press Start.
• In case of INPUT Component: Indicates current status in Status column. Count up (+1) when switching. (High to Low, Low to High)
• In case of OUTPUT Component: Activates component - Press Stop button after confirming.
Stacking Components
NOTE: Some components cannot be energized at the same time as another component. If you activate such a combination of components, the first component switched on will be automatically switched off.
- When performing multiple component checking, input new Chain-Link number after one (or several) component(s) is (are) in operation. NOTE: Only latest Chain-Link number is displayed.
- When confirming the status of another component still in operation, select Enter Number then input Chain-Link number of applicable component.
- Select Stop key after confirming. Stop operation of component indicated on screen.