Xerox WorkCentre 5325

Purpose

The purpose of the Component Control is to display the logic state of input signals and to energize output components.

Procedure

1. Enter Diagnostic Mode (Accessing UI Diagnostics).
2. Press the Machine Status button on the Control Panel.
3. Select the Tools tab on the UI screen.
4. System Settings and Common Service Settings will be highlighted.
5. In the Features column, select Maintenance / Diagnostics. Scroll to and select IO Check.
6. Select Component Control.
7. Input Chain-Link number, then press Start.
   • In case of INPUT Component: Indicates current status in Status column. Count up (+1) when switching. (High to Low, Low to High)
   • In case of OUTPUT Component: Activates component
8. Press Stop button after confirming.

Stacking Components

NOTE: Some components cannot be energized at the same time as another component. If you activate such a combination of components, the first component switched on will be automatically switched off.

1. When performing multiple component checking, input new Chain-Link number after one (or several) component(s) is (are) in operation. NOTE: Only latest Chain-Link number is displayed.
2. When confirming the status of another component still in operation, select Enter Number then input Chain-Link number of applicable component.
3. Select Stop key after confirming. Stop operation of component indicated on screen.