Xerox Phaser 3040

The CE Diagnostic software extends the functionality of the Printer Settings Utility by adding a Service Diagnostics selection. CE Dagnostics provide a way to test electromechanical components, display printer status, and provide NVRAM access. When a PC is available, use CE Dagnostic software tests to diagnose problems and isolate which component or sub assembly needs replacement.

• Exit Sensor
• Registration Sensor
• Rear Door Interlock Switch
• Toner Cartridge CRUM

Exit Sensor

1. Enter CE Diagnostics
2. Run the Exit Sensor test in the Digital Input drop down box.
3. Operate the actuator to check sensor function.
4. Confirm the display indicates the sensor functions correctly.
5. Press the Cancel button to stop the test.

Registration Sensor

1. Enter CE Diagnostics
2. Open the Rear Door.
3. Run the Registration Sensor test.
4. Operate the actuator to check sensor function.
5. Confirm the display indicates the sensor functions correctly.
6. Press the Cancel button to stop the test.
7. Close the Rear Door.

Rear Door Interlock

1. Enter CE Diagnostics
2. Run the Interlock Switch test
3. Open and close the Rear Door to actuate the switch.
4. Confirm the display indicates the sensor functions correctly.
5. Press the Cancel button to stop the test.
6. Close the Rear Door.