Toshiba e-Studio 506
Adjustment. Image Dimensional
There are several adjustment items in the image dimensional adjustment, as listed below. Prior to this image dimensional adjustment, perform "Forced performing of image quality closed-loop control (FS- 05-2742)". When adjusting these items, the following adjustment order should strictly be observed.
Item to be adjusted | Code in 05 Adjustment Mode | |
---|---|---|
1. Paper alignment at the registration roller | 4100, 4101, 4103, 4104, 4105, 4106, 4107,4108, 4109, 4110, 4111, 4115, 4116, 4117, 4118, 4119, 4120 | |
2. Printer related image dimensional adjustment | Reproduction ratio of the primary scanning direction | 4001 |
Primary scanning data writing start position | 4006 | |
Reproduction ratio of the secondary scanning direction (Fine adjustment of main motor rotation speed) |
4009 | |
Secondary scanning data writing start position | 4058, 4059, 4060, 4061, 4062, 4063 | |
Primary scanning data writing start position at duplexing | 4019 | |
Secondary scanning data writing start position at duplexing | 4062 | |
3. Scanner related image dimensional adjustment | Image distortion | 3033 |
Reproduction ratio of the primary scanning direction | 4000 | |
Primary scanning data writing start position | 3030 | |
Reproduction ratio of the secondary scanning direction | 3032 | |
Secondary scanning data writing start position | 3031 | |
Top margin | 4050 | |
Right margin | 4052 | |
Bottom margin | 4053 |
[Procedure to key in adjustment values] In accordance with the procedure described below, adjust the value of each item so that the measured values obtained from test copies satisfy the specification. By pressing [TEST COPY] in the ready state of 05 Adjustment Mode, single sided test copying in the normal copy mode can be performed.