Toshiba e-Studio 351c

(1) Preparation

• Ask the user about the current conditions of the equipment and note them down.
• Before starting maintenance, make some sample copies and store them.
• See the replacement record and check the parts to be replaced in the PM support mode (6S- 2) or list printing mode (9S-103).
  
  6S-2 : [6] + [START] + [POWER] ON → [2] → [START]
  9S-103 : [9] + [START] + [POWER] ON → [103] → [START]
• Turn OFF the power and make sure to unplug the equipment.

(2) Perform a preventive maintenance using the following checklist and illustrations. Refer to the Service Manual if necessary.

(3) Plug in the equipment after the maintenance has been finished. Then turn ON the power and make some copies to confirm that the equipment is working properly.

Operational Items in Overhauling

Overhaul each equipment with the following timing.

e-STUDIO281c: When the number of output pages has reached 300,000 or 2.5 years have passed from the start of use (Whichever is earlier.)

e-STUDIO351c: When the number of output pages has reached 360,000 or 2.5 years have passed from the start of use (Whichever is earlier.)

e-STUDIO451c: When the number of output pages has reached 450,000 or 2.5 years have passed from the start of use (Whichever is earlier.)

1. Replace all the supplies.
2. Check the components in the drive section (gears, pulleys, timing belts, etc.). Replace them with new ones if they are damaged.
3. Check all the adhesives such as tape and Mylar if they are damaged or have become unstuck. Replace them with new ones if necessary.
4. Check the performance of all the switches and sensors. Replace them with new ones if necessary.
5. Clean inside the equipment thoroughly.