Toshiba e-Studio 351c
Service Mode. How to Enter
Self-diagnosis Modes
| Mode | For start | Contents | For exit | Display |
|---|---|---|---|---|
| Control panel check mode | [0]+[1]+ [POWER] | All LEDs on the control panel are lit, and all the LCD pixels blink. | [POWER] OFF/ON | - |
| Test mode | [0]+[3]+ [POWER] | Checks the status of input/output signals. | [POWER] OFF/ON | 100% C A4 TEST MODE |
| Test print mode | [0]+[4]+ [POWER] | Outputs the test patterns. | [POWER] OFF/ON | 100% P A4 TEST PRINT |
| Adjustment mode | [0]+[5]+ [POWER] | Adjusts various items. | [POWER] OFF/ON | 100% A A4 TEST MODE |
| Setting mode | [0]+[8]+ [POWER] | Sets various items. | [POWER] OFF/ON | 100% D TEST MODE |
| List print mode | [9]+[START]+ [POWER] | Prints out the data lists of the codes 05 and 08, PM support mode and pixel counter. | [POWER] OFF/ON | 100% UA A4 LIST PRINT |
| PM support mode | [6]+[START]+ [POWER] | Clears each counter. | [POWER] OFF/ON | 100% K TEST MODE |
| Firmware update mode | [8]+[9]+ [POWER] | Performs updating of the system firmware. | [POWER] OFF/ON | - |
Note:
To enter the desired mode, turn ON the power while two digital keys designated to each mode (e.g. [0] and [5]) are pressed simultaneously.
To exit from Adjustment mode and Setting mode:
Shut down the equipment. When the power should be turned OFF, be sure to shut down the equipment by pressing the [ENERGY SAVER] button for a few seconds.