Toshiba e-Studio 320P

Entering Diagnostic Mode

1. Turn the printer off.
2. Press and hold the Go and Return buttons.
3. Turn the printer on.
4. Release the buttons when Performing Self Test displays on the operator panel.

The tests are displayed on the operator panel in the order shown:

REGISTRATION
PRINT TESTS
Tray 1
Tray 2 (displays only if installed)
Tray 3 (displays only if installed)
MP Feeder
Prt Quality Pages
HARDWARE TESTS
LCD Test
Button Test
DRAM Test
Parallel Wrap (displays in some configurations)
DUPLEX TESTS
Quick Test
Top Margin
Sensor Test
Duplex Feed 1
INPUT TRAY TESTS
Feed Test
Sensor Test
BASE SENSOR TEST
Toner
Input
Output
Narrow Media
Front Door
DEVICE TESTS (only displays if flash is installed)
Flash Test
PRINTER SETUP
Defaults
Page Count
Perm Page Count
Serial Number
Engine Setting 1
Engine Setting 2
Engine Setting 3
Engine Setting 4
Model Name
Configuration ID
Edge to Edge
Par S Strobe Adj
EP SETUP
EP Defaults
Fuser Temp
Transfer
Print Contrast
Charge Roll
Gap Adjust
ERROR LOG
Display Log
Print Log
Clear Log

Select Exit Diagnostics to exit the Diagnostics Mode and return to normal mode.