PrintCopy.info service

Toshiba e-Studio 220P

 All About this machine
Table Of Contents 

Service checks 01

Service checks involve measuring voltages of the LVPS, HVPS, and controller card assembly. Continuity and resistance verifications are done on cables and components as required.

Note:
When looking at the printed side of a printed circuit board, connectors are designated with “J” followed by a number. Pin #1 is designated on the board by an adjacent “1” or triangle. Pin numbers index sequentially to the opposite end of the connector. See “Controller card assembly” for more information.

The controller card passes +5 V dc and +24 V dc from the LVPS to its clients. Therefore, when either voltage is missing as an output on the controller card, be sure to verify the inputs from the LVPS (J17, sockets 1 and 2 at +24 V dc and socket 5 at +5 V dc).

Cooling fan service check

FRU Action
Cooling fan (fuser)
Cooling fan (LVPS)

Make sure the plugs of the cooling fan cables are properly seated.
Both fans are connected to the same +24 V dc on pin #1 at J19 on the controller. Pin #2 is ground for both fans. Therefore if one fan functions and the other does not, either the fan or the cable is faulty. Turn the printer off and disconnect the cooling fan cable at the suspect cooling fan. Turn the printer on. Within approximately 15 seconds the controller card assembly should apply +24V dc to the fan. See “Controller card assembly” for more information.

  • If voltage is present, reconnect the fan to verify the fan is faulty. If it is, replace the fan.
  • If voltage is not present, disconnect the cable from the controller card (J19) and check for continuity on each cable.
    • If the cable is good, see “Controller card service check” for more information.
    • If the cable is damaged, replace the cable.

Cover interlock switch service check

Note:
Make sure a print cartridge is installed and the cover closes all the way, fully engaging the cover open switch lever.

FRU Action
Cover interlock switch

Disconnect the cover interlock cable from the interlock switch.
Push the cover interlock switch to the closed position and verify continuity between the bottom and middle terminals.
Open the switch and verify continuity between the bottom and top terminals. The top and middle terminals should indicate discontinuity at all times.

  • If the switch is good, verify +5 V dc on the middle spade of the cable and ground on the top spade of the cable.
  • If voltage is not present, see “Controller card service check”.

Replace the switch if faulty.
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us