Sharp MXM160

d. Paper off center adjustment (SIM50-10)

1. Set a test chart (UKOG-0089CSZZ) on the document table.
2. Select a paper feed port and make a copy. Compare the copy and the test chart. If necessary, perform the following adjustment procedure.
3. Execute SIM 50-10. After completion of warm-up, shading is performed and the currently set off center adjustment value of each paper feed port is displayed
4. Enter the set value and press the [START] key. The correction value is stored and a copy is made.

Duplex mode adjustment

* 2nd print surface (auto duplex) off-center adjustment: SIM50-10 (TEXT, 1st tray indicator)

e. Side edge void area adjustment (SIM26-43)

Note:
Before performing this adjustment, be sure to check that the paper off center adjustment (SIM 50-10) is completed.

1. Set a test chart (UKOG-0089CSZZ) on the document table.
2. Select a paper feed port and make two copies. Compare the 2nd copy and the test chart. If necessary, perform the following adjustment procedure.
   *The 1st copy does not show the void. Be sure to check the 2nd copy.
3. Execute SIM 26-43 and set the density mode to AUTO(right edge void) + TEXT (Left edge void). The currently set adjustment value is displayed.
4. Enter the set value and press the [START] key. The correction value is stored.

* The void adjustment values on the right and the left must be the same.