Sharp MXM160

b. SPF image lead edge position adjustment (SIM50-6)

1. Set a scale on the OC table as shown below.
   Note: Since the printed copy is used as a test chart, put the scale in paralled with the edge lines.
2. Make a copy, Then use the copy output as an original to make an SPF copy again.
3. Check the copy output. If necessary, perform the following adjustment procedures.
4. Execute SIM 50-6.
5. Set the SPF lead edge position set value (AUTO indicator ON) so that the same image is obtained as that obtained in the previous OC image lead edge position adjustment.

c. Rear edge void adjustment (SIM50-1, SIM50-19)

1. Set a scale as shown in the figure below.
2. Set the document size to A4 (8.5" x 11"), and make a copy at 100%.
3. If necessary, perform the following adjustment procedure.
4. Execute SIM 50-1 and set the density mode to AUTO + TEXT + PHOTO (Rear edge void).The currently set adjustment value is displayed.
5. Enter the set value and press the [START] key. The correction value is stored and a copy is made.

Duplex mode adjustment

• 1st print surface (auto duplex) rear edge void adjustment: SIM50-19 <<AUTO>>
• 2nd print surface (auto duplex) rear edge void adjustment: SIM50-19<<TEXT>>
• Set to S → D mode before execution.

Note:
Before performing the 2nd print surface rear edge void adjustment, be sure to perform the 2nd print surface lead edge position adjustment. Never reverse the sequence.