Samsung Xpress M2070FW
Service Mode. 1. How to Enter
In service (tech) mode, the technician can check the machine and perform various test to isolate the cause of a malfunction.
Entering Tech mode
For M2070F / M2070FW
- Press “Menu > # > 1 > 9 > 3 > 4” on the control panel continuously.
- Press Menu.
- Select “Tech Mode”.
For M2070W / M2070
- Press “Menu > Back > Left arrow > Right arrow > OK > Stop” on the control panel continuously.
- Press Menu.
- Select “Tech Mode”.
Tech mode menu
Depth 1 | Depth 2 | Depth 3 | Depth 4 |
---|---|---|---|
Data Setup | Send Level | [9-15] | 12 |
DTMF Level | High [0-15] | Low [0-15] | |
Pause Time | [1-9] | ||
Dial Mode | Tone | ||
Pulse | |||
Modem Speed | 33.6 | ||
28.8 | |||
14.4 | |||
12.0 | |||
9.6 | |||
4.8 | |||
Error Rate | 10% | ||
5% | |||
Clear All Mem. | |||
TonerLow Level | [1-30]% | ||
Clear Counts | Enter Passcode [????] | ADF Scan | |
Platen Scan | |||
Fuser | |||
TransferRoller | |||
Pickup Roller | |||
ADF Roller | |||
Engine Footer | Off | ||
On | |||
Dial Tone | On | ||
Off | |||
Caller ID | On | ||
Off | |||
Busy Tone | On | ||
Off | |||
Wrap Jam Clear | Yes | ||
No | |||
F/W Upgrade | Off | ||
On | |||
Machine Test | Switch Test | ||
Test Param Set | |||
Modem Test | |||
DRAM Test | |||
ROM Test | |||
Shading Test | Shading&Print | ||
Scan Aging | |||
Report | Protocol Dump | ||
Supplies Info. | |||
Configuration | |||
Error Info. | |||
Usage Counter | |||
ComponentCheck | |||
Fax Options | |||
EDC Mode | NVM Initialize | ||
Test Routines | 100-Motor | Feed Mot | |
Feed Mot Slow | |||
101-Clutch | Tray1 Pickup | ||
102-Sensor | Feed Sens | ||
Width Sensor | |||
105-Charger | K MHV Bias | ||
106-Development | K Dev Bias | ||
K Dev AC | |||
107-Transfer | K THV Bias | ||
K THV- Bias | |||
109-Fuser | Temp A | ||
110-LSU | LSU Mot1 Run |