-
Catalog
-
Sign In
-
Contacts
-
Forum
-
Eng
Samsung SLM4030ND
Service Mode. Service Function
- Clear All Mem.
The function resets the system to factory default settings. This function is used to reset the system to the initial value when the product is functioning abnormally . All the values are returned to the default values, and all the information, which was set by the user, will be erased.
NOTE
Always perform a memory clear after replacing the main board. Otherwise, the system may not operate properly.
- Clear Admin PW
This menu resets the Admin password.
- Engine Footer
This function is for monitoring of the engine status. If you perform this function, at printing, the setting value for engine is shown on the bottom of the printed page.
- F/W Upgrade
The function is to upgrade the firmware.
- Capture Log
This function copies all the saved log in the system to a UBS memory as a zip file.
- Envelope Rotate
This menu is enabling rotate when printing on envelope. The machine usually guides to load envelope with SEF direction. If this function is enabled, the user can load envelope with LEF direction and the machine shall rotate image for printing exactly on envelope.
This function shall provide the setting options as follows:
- Off (default) : Load envelope SEF direction
- 90 degrees : Load envelope LEF direction
- 180 degrees : Load envelope SEF direction with flap is bottom side
NOTE
1) If the paper source is 'Auto', the device shall feed from MP Tray. Because the LEF envelope can be loaded only in MP Tray according to Paper Specification.
2) If the length of envelope is over max size of custom width, the device shall not rotate image and just determine the direction of envelope is SEF. For example, the A4 model support custom size like W 98-216 ~ L148-356. This model doesn't support C5 Env.(162x229) DL Env.(110x220), No9 Env.(98x225), No10 Env.(105x241) rotation.
- SFE
Special Feature Enablement (SFE) means to provide the configurable options (On/Off) in service mode for technicians or dealers to satisfy the requirements from B2B sites easily without changing the firmware installed in a device.