Samsung SCX6545NX

Information tab provides detail information of the machine.

General

• Diagnostics>Information>General
• When user selects General, OP displays Machine Serial Number, Network IP Address and Images since last call.

HFSI (High Frequency Service Items)

• Diagnostics>Information>HFSI
• When user selects General, OP displays the list of HFSI( High Frequency Service Items) read from the MCB. In the list, there are “ Item”, “Status”, “Actual”, and “Max Life”.
• User Behavior
  - User can select one item in the list to reset the counter using “Reset” button or to edit the Max.Life and threshold value using “Edit” button.
• Items in this column are:
  DADF Roller / Rubber Pad Life Page
  T1/T2/T3 P-up Roller Life Page
  Retard Roller Life Page
  Bypass Rubber Pad Life page
  Transfer Roller Life Page
  Fuser Roller / Fuser Unit Life Page
  Heat Roller Life Page
  Pressure Roller Life Page
• Status
  - The possible values in this column are 'OK', 'Check', 'Negative' and 'Off'.
  - OK : Actual counter is smaller than the threshold value
  - Check : Actual counter is bigger than threshold value but smaller than Max.Life
  - Off : Actual counter exceeds Max.Life
  - Negative : There is no counter to display. In this case, it shall display '-' in the Status and Max Life column.
• Actual
  - Values in this column are actual counts for HFSI usage
• Max. Life
  Values in this column are maximum life limits set for HFSI.
• Reset
  This button is used to reset the actual counter after replacing the HFSI unit. This button is disabled before user select one item in the list and enabled once user select any of the items in the list. Once user presses, a confirmation window shall display to user confirm again. The window is displayed as below. If user confirms reset, it will reset the counter to 0. If the counter of selected item is 0, ‘Reset’ button shall be disabled.
• Edit
  “Edit” button is disabled until user select one item in the list. Selecting “Edit” button causes edit window to be displayed. There are two input filed for ‘Maximum Life’ and for ‘Threshold’. Each data field shall display default value or the last-saved value entered by the service engineer. The data field shall support the numeric characters of 0 to 9. The hard keypad characters of ‘#’, ‘phone’ and ‘*’ are not supported and shall generate an invalid entry message if selected. The hard keypad characters of ‘c’ shall delete all characters displayed within the selected data field. By selecting ‘Cancel’, window moves back to HSFI window without saving user’s setting. By selecting ‘OK’ button, window moves back to HSFI window saving user’s setting. Threshold value shall not be greater than Maximum Life.