PrintCopy.info service

Samsung SCX6545N-XBH

 All About this machine
Table Of Contents 

Diagnostics Mode. Test Routines Tab. Engine/DADF Test Routines 4

8) Fuser

Code Displayed Name Meaning State Displayed
10-100 Fuser Power On It controls temperature of fuser as 180 degrees. On[Off]
10-200 Fuser Temperature A Detects what the temperature A is on fuser. Numeric 3 digits
10-210 Fuser Temperature B Detects what the temperature B is on fuser. Numeric 3 digits
10-300 Fuser Unit Fault Detects if the IH board for controling fuser is normal. Normal/Fault
10-400 Fuser Motor Forward Fuser Motor Forward On/Off On[Off]
10-500 Fuser Fan Run Start/Stop Fuser Fan run On[Off]
10-600 Fuser Bias Fuser bias voltage on at normal drive level On[Off]

9) Finisher

Code Displayed Name Meaning State Displayed
12-100 Entrance Motor Entrance Motor run as IOT Speed <about 5 sec> On[Off]
12-110 Exit Motor Exit Motor run as IOT Speed <about 5 sec> On[Off]
12-200 Paddle Motor Paddling On
12-300 Front Jog Home Front Jogger move Home On
12-310 Front Jog Stand Front Jogger move to Stand On
12-320 Rear Jog Home Rear Jogger move Home On
12-330 Rear Jog Stand Rear Jogger move to Stand On
12-400 Support Finger Home Supporter move Home On
12-410 Support Finger Stand Supporter move to Stand On
12-500 Ejector Motor Ejecting On
12-600 Stacker Down Stacker down to bottom On
12-610 Stacker Up Stacker up to Stacking position On
12-700 Stapler Staple when no cartridge On
12-800 Entrance Sensor Detect paper at paper feeding area. High[Low]
12-805 Exit Sensor Detect paper at paper exit area. High[Low]
12-810 Paddle Home Sensor Detect Paddle Home position High[Low]
12-815 Front Jog Home Sensor Detect Front Jog Home position High[Low]
12-820 Rear Jog Home Sensor Detect Rear Jog Home position High[Low]
12-825 Support Finger Home Sensor Detect Support-Finger Home position High[Low]
12-830 Ejector Home Sensor Detect Ejector Home position High[Low]
12-835 Ejector Encoder Sensor Detect Ejector Encoder sensor High[Low]
12-840 Stacker Top Sensor Detect Stacker Top position High[Low]
12-845 Stacker Bottom Switch Detect Staple Bottom position High[Low]
12-850 Staple Home Sensor Detect Staple Home position High[Low]
12-855 Staple Ready Sensor Detect Staple Ready to clinching. High[Low]
12-860 Low Staple Sensor Detect Staple Low High[Low]
12-865 Paper Detector Sensor Detect paper in stapler area High[Low]
12-870 Finisher Door Switch Detect Finsher Door Open or Close High[Low]
12-875 IOT Set Sensor Detect Finisher is connected with IOT. High[Low]
12-880 Duplex Paper Sensor Deetct Duplex Paper feeding from IOT. High[Low]
Error Code
Service Mode, Troubleshooting
Parts Catalog
Compatibility
Downloads Files
Home
New Register Forgot Password?
Send message to us