Riso GR3770
Test Mode. 5. Memory Clear and Counter Stop, etc.
No. | Details of Test Mode |
---|---|
90 | Partial Memory Clear Certain portion of RAM contents in the System PCB, such as Jam and Trouble messages, will be initialized. (The same operation as when turning the power ON while pressing All Reset button.) |
91 | Master Marking Width Ceck (Except for GR1700) |
92 | Prevention of the following operations: master and copy counting, Key/card counter and “T17 CALL SERVICE” or [E17] error signal display (for dead battery)
Do not use this mode when TM5000 is in connection. |
97 | All Memory Clear All RAM contents in the System PCBs, excluding Memory switch setting by Test modes, that is No.81 through 87, will be initialized. Master disposal count is not cleared. NOTE: This test mode must be done each time System ROM, System PCB, or Battery is changed. |
98 | Memory Switch Clear Memory switch settings by Test modes No.81 through 87 will be initialized. This test mode must be done each time System PCB is changed. [CAUTION] Do not use this test mode in normal operation. All the programmed Memory switch settings in the machine will be initialized. |