Riso EV3790
Test Mode. 3. System & Control Panel Test Mode EZ2/EV2 & EZ3/EV3 1
No | Sensor & Switch Check |
---|---|
0001 | Wakeup Key ON: Key pressed |
0002 | Solenoid counter connection signal ON: Solenoid counter connected |
0003 | 24V A output signal ON: 24V-A (24 volts) is output |
0004 | 24V B output signal ON: 24V-B (24 volts) is output |
0005 | Rear cover safety switch ON: Rear cover is attached |
No | Motor & Solenoid |
---|---|
0062 | Wake-up LED LED Illuminates |
No | Unit Check |
---|---|
0080 | Test Print A (checkered) Creates Test pattern 1 (Checker Flag) |
0081 | Test Print B (cross stripes) Creates Test pattern 2 (Cross Lines) |
0082 | Test Print C (Dot1) Creates Test pattern 4 (Dot 1 ) |
0083 | Test Print D (Dot2) Creates Test pattern 5 (Dot 2 ) |
0084 | Test Print E (Dot1 + Cross Lines) Creates Test pattern 6 (Dot 1 + Cross Lines) |
0085 | Test Print F (Dot2 + cross stripes) Creates Test pattern 7 (Dot 2 + Cross Lines) |
0086 | Test Print G (Dot3) Creates Test pattern 8 (Dot 3 ) |
0087 | Paper-Feed Test (continuous feeding) Speed 1 = 60rpm Speed 2 = 80rpm Speed 3 = 100rpm Speed 4 = 120rpm Speed 5 = 130rpm |
0088 | Low-Speed Printing Operation Prints continuously at 15 rpm. |
0089 | Stepped Printing Operation Press START key to switch on the suction fan. Prints at 15 rpm only while TEST PRINT key is pressed. Printing stops when TEST PRINT key is released, and resumes if the key is pressed again. Press STOP to switch suction fan off. |
0090 | Firmware download Firmware is downloaded when START key is pressed. |
0094 | Unit Initialization Mechanical initialization is made. (Scanner, TPH, Compression plate,Clamp unit, Vertical print position, Printing pressure) |
0095 | System Configuration Data Output |
Creates a master for the CI system data. | |
0101 | Machine Clock Activation |
Activates time set by Test Modes from No.0171 through 0173. The new clock time set by test mode No. 0171 through No.0173 will not be applied unless this test mode No. 0101 is activated. | |
0103 | Machine Test Mode Data Recording |
Stores the machine Test Mode settings into CF card. | |
0104 | Print drum Test Mode Data Recording |
Stores the Print drum Test Mode settings in the EEPROM of the Print Drum PCB into CF card. | |
0105 | Machine Test Mode Data Re-store |
Writes the test mode settings retrieved in CF card by test mode No.0103 into the NeoROSA PCB. | |
0106 | Print Drum Test-Mode Data Re-store |
Writes the test mode settings retrieved in CF card by test mode No.0104 into the Print Drum PCB EEPROM. | |
0107 | Test Mode Data Back-up |
Stores all the test mode numbers and settings, which are changed from the program default, are stored in CF card for record keeping purpose. |