Ricoh MPC2503
Maintenance. 2. After Installing the New PM parts
After Installing the New PM parts
- Turn on the main power switch.
- Output the SMC logging data with SP5-990-004 and check the counter values.
- Make sure that the PM counters for the replaced units are "0" with SP7-944. If the PM counter for a unit was not reset, then reset that counter with SP 7-622.
- Make sure that the exchange counter counts up with SP7-853.
- Make sure that the counters for the previous units (SP7-908) on the new SMC logging data list (from step 2 above) are equal to the counters (SP7-803) for these units on the previous SMC logging data list (the list that was output in the "Before removing the old parts" section).
- Make sure that the unit replacement date is updated with SP7-950.
Preparation before Operation Check
- Clean the exposure glasses (for DF and book scanning).
- Enter the user tools mode.
- Do the "Automatic Color Calibration(ACC)" for the copier mode & printer mode as follows:
• Print the ACC test pattern (User Tools Maintenance ACC Start).
• Put the printout on the exposure glass.
• Put 10 sheets of white paper on the test chart. This ensures the precise ACC adjustment.
• Close the ARDF or the platen cover.
• Press "Start Scanning" on the LCD. Then, the machine starts the ACC. - Exit the User Tools mode, and then enter the SP mode.
- Perform line adjustment.
SP2-111-004: Forced Line Position Adj. Mode d
The result can be checked with SP2-194-007 (MUSIC Execution Result Execution Result)
(0:Succeed, 1: Fail).
Also, results for each color can be checked with SP2-194-010 to 013. - Exit the SP mode.
Operation Check
Check if the sample image has been copied normally.