Ricoh MP2001
Adjustment. Printing. Registration - Leading Edge/Side-to-Side
You need to perform the adjustment after you do a Memory All Clear, and after you replace or adjust any of the following parts.
• First or second scanner
• Lens Block
• Scanner Motor
• Polygonal Mirror Motor
• Paper Tray
• Paper Side Fence
Note:
- Make sure the paper is installed correctly in each paper tray before you start these adjustments.
- Use the Trimming Area Pattern SP5-902, No. 10 (D160/D161/D170) or SP2-109, No.14 (D158/D159) to print the test pattern for the printing adjustments below.
- Set SP5-902 (D160/D161/D170) or SP2-109 (D158/D159) to 0 again after you complete these printing adjustments.
- Check the leading edge registration for each paper feed station, and adjust each of these registrations using SP1-001.
- Check the side-to-side registration for each paper feed station, and adjust these registrations using SP1-001. (Adjust the trays in order: the 1st tray first, then the 2nd tray, etc.)
A: Leading Edge Registration
B: Side-to-side Registration
Tray | SP mode | Specification |
---|---|---|
Any paper tray: Plain | SP1-001-002 | 2 ± 1.5 mm |
Any paper tray: Mid Thick | SP1-001-003 | |
Any paper tray: Thick | SP1-001-004 | |
By-pass feed: Plain | SP1-001-007 | |
By-pass feed: Mid Thick | SP1-001-008 | |
By-pass feed: Thick | SP1-001-009 | |
Duplex: Plain | SP1-001-013 | |
Duplex: Mid Thick | SP1-001-014 | |
Duplex: Thick | SP1-001-015 | |
By-pass feed | SP1-002-001 | |
Tray Main 1 | SP1-002-002 | |
Tray Main 2 | SP1-002-003 | |
Tray Bank 1 | SP1-002-004 | |
Tray Bank 2 | SP1-002-005 | |
Duplex | SP1-002-006 |