Ricoh M257 SPC440DN Z-P2

Service Mode Operation

• The Service Program Mode is for use by service representatives only so that they can properly maintain product quality. If this mode is used by anyone other than service representatives for any reason, data might be deleted or settings might be changed. In such case, product quality cannot be guaranteed any more.

Accessing the Required Program

Use the "Up/Down arrow" keys to scroll through the menu listing.

1. Service: Controller service modes
2. Engine: Engine service modes
3. End: Exit service mode

To select an item, press the "OK" key. Then the sub-menu shows.
Scroll through the sub menu items using the "◄ ►" keys.
To go back to a higher level, press the "Escape" key.

Inputting a Value or Setting for a Service Program

Enter the required program mode as explained above. The setting appearing on the display is the current setting.

Select the required setting using the "◄ ►" keys, then press the "OK" key. The previous value remains if the "OK" key is not pressed.

Exiting Service Mode

Select "End" from the service mode main menu, then press the "OK" key.

• To make the settings effective, turn the main switch off and on after exiting service mode.