Ricoh M160 SP4510SF Gim-MF1d

Scanner Image Adjustment

Before the scanner adjustment, do the Side-to-Side registration and blank margin width adjustment.

Note:
Use a test chart to adjust these settings

Magnification

A: Sub-scan magnification

1. 1. Place the test chart on the exposure glass and make a copy from one of the paper feed trays.
2. Check the magnification ratio. If necessary, adjust the magnification with the following SP mode

SP No.	Name	Specification
SP4-008	Sub-scan magnification	± 1.0%

Registration

A: Leading edge registration
B: Side-to-side registration

1. Place the test chart on the exposure glass and make a copy from one of the paper feed trays.
2. Check the leading edge and side-to-side registration, and adjust as necessary with the following SP modes.

SP No.	Name	Range
SP4-010-00	L-Edge Regist Adjustment1	0 ± 2mm
SP4-011-001	S-to-S Regist Adjustment	0 ± 2.5mm

SPDF Image Adjustment

Use the above test charts to adjust these settings.

1. Place the temporary test chart on the SPDF and make a copy from one of the paper feed trays.
2. Check the registrations, and adjust as necessary with the appropriate SP modes, as follows.
   Allowable registration errors: 4.2 ± 2 mm (Leading edge) / 2 ± 1 mm (Left, right)

SP No.	Name	Range
SP6-006-001	Side-to-Side Regist: Front	± 2.0 mm
SP6-006-003	Leading Edge Regist: Front	± 5.0 mm
SP6-006-007	Rear Edge Erase	± 5.0 mm

Magnification

1. Place the temporary test chart on the SPDF and make a copy from one of the paper feed trays.
2. Check the magnification and adjust it with SP6-017-001 if necessary

SP No.	Name	Range
SP6-017-001	SPDF Adjustment Magnification	± 5.0 %