Ricoh M159 SP4520DN Gim-P1dM
Troubleshooting. Test Pattern Printing
Follow the test pattern print procedure below to print a test pattern.
Note:
• Do not operate the machine until the test pattern has been printed. Otherwise, an SC occurs.
- Enter the SP mode, and then select SP2-109-001.
- Select the pattern number, and then press [OK].
- Do the following SP to print the test pattern.
SP SP2-109-002 Test Printing 1 Sheet SP2-109-003 Test Printing Cont. Printing (On: Continue /Off: Stop) SP2-109-004 Test Printing Print Side Select - Check the test pattern.
No. | Pattern |
---|---|
0 | None |
1 | Vertical Line (1 dot) |
2 | Horizontal Line (1 dot) |
3 | Vertical Line (2 dot) |
4 | Horizontal Line (2 dot) |
5 | Grid Vertical Line |
6 | Grid Horizontal Line |
7 | Grid 20mm Pitch |
8 | Slanting Grid |
9 | Slanting Grid 20mm Pitch |
10 | Independent Pattern (1 dot) |
11 | Independent Pattern (2 dot) |
12 | Independent Pattern (4 dot) |
13 | Full Dot Pattern |
14 | Band |
15 | Gray 10mm Pitch |
16 | Gray 20mm Pitch |
17 | Trimming Area |