Ricoh G1127
Maintenance. PM Parts Settings
PM Parts Replacement Procedure
- Enter the SP mode.
- Print the SMC logging data. (SMC Page Printing)
- Execute the following SPs to "1".
Item SP No. SP Name OPC Drum SP7-622-021 PM Counter Reset OPC Developer SP7-622-024 PM Counter Reset Developer Mixing Auger Bearings SP7-622-028 PM Counter Reset Bearing:Dev Screw Transfer roller SP7-622-108 PM Counter Reset Paper Trans Unit Fusing unit SP7-622-115 PM Counter Reset Fusing Unit Hot Roller Bearings SP7-622-119 PM Counter Reset Fusing Roll Bear - Exit the SP mode.
- Turn off the main power.
- Replace the PM parts and turn the power on. The machine will reset the PM counters.
After Installing the New PM parts
- Turn on the main power.
- Output the SMC logging data (SMC Page Printing) and check the counter values.
- Make sure that the PM counters for the replaced units are "0" with SP7-621 and SP7-944.
Operation Check
Check if an example image is copied normally.