Ricoh D224 MP7503SP
Adjustment. Printing. Blank Margin
These adjustments must be performed after replacing any of the following parts:
• Scanner wires
• Lens block
• Scanner motor
• Polygon motor
• Tandem tray side fences
• Memory All Clear
Preparation
- Make sure paper is installed correctly in each paper tray before you start these adjustments.
- Use the Trimming Area Pattern (SP2-902-3, No. 18 to print the test pattern for the following procedures.
- After completing these printing adjustments, be sure to set SP 2-902-3 to 0 again.
Procedure
If the leading edge/side-to-side registration cannot be adjusted within specifications, adjust the leading/left side edge blank margin.
- Check the trailing edge and right edge blank margins, and adjust them with the following SP modes.
A Trailing edge blank margin
B Right edge blank margin
C Leading edge blank margin
D Left edge blank margin
SP2101 Print Erase Margin
SP mode | Specification | |
---|---|---|
Leading Edge | SP2101-001 | 2.5±2 mm |
Trailing Edge | SP2101-002 | |
Left edge | SP2101-003 | 2±1.5 mm |
Right edge | SP2101-004 |