Ricoh D223 MP6503SP
Adjustment. Printing. Registration Buckle Adjustment
These adjustments must be performed after replacing any of the following parts:
• Scanner wires
• Lens block
• Scanner motor
• Polygon motor
• Tandem tray side fences
• Memory All Clear
Preparation
- Make sure paper is installed correctly in each paper tray before you start these adjustments.
- Use the Trimming Area Pattern (SP2-902-3, No. 18 to print the test pattern for the following procedures.
- After completing these printing adjustments, be sure to set SP 2-902-3 to 0 again.
Procedure
When the customer is using special paper, buckle adjustment may be required if paper feed problems arise.
- If the buckle is too large, this can cause wrinkling, creasing, or jams caused by sheets overtaking the sheets ahead of them in the paper path.
- If the buckle is too small, this can cause jams at the registration roller or skew during paper feed.
- Enter the SP mode.
- Open SP1003.
• To prevent wrinkling, creasing, or jams, set a smaller value.
• To prevent jams at the registration roller or to eliminate skew, set a larger value.
SP1003-001 | Registration Buckle Adjustment – Tray, LCT |
SP1003-002 | Registration Buckle Adjustment – Duplex Tray |
SP1003-003 | Registration Buckle Adjustment – Bypass Tray |
Adjustment range | -9 mm -> +9 mm (small -> large buckle) |
Initial value | 0 mm (Buckle = 10 mm) |