Ricoh D198 MP3054SP Cor-C1
Troubleshooting. Test Pattern Printing
Printing Test pattern: SP2-109
Some of these test patterns are used for copy image adjustments but most are used primarily for design testing. These test patterns do not use the IPU.
Note:
• Do not operate the machine until the test pattern is printed out completely. Otherwise, an SC may occur.
- Enter the SP mode then select SP2-109-003 “Pattern Selection”.
- Select test pattern for print from the list then press [OK].
- To change the density of the test pattern, select the density with SP2-109-006, then press [#].
• If select "0" with SP2-109-006, the color adjusted so will not show up in the test pattern. - To print, touch [Copy Window], then set settings within the following window for test print (paper size etc…).
- Press "Start" key to start test print.
- After checking test pattern, touch "SP Mode" on the LCD to return to SP mode display.
- Reset all settings to the default values (SP2-109-003, SP2-109-006).
- Exit SP mode.
Test Pattern Table
No. | Test Pattern |
---|---|
0 | None |
1 | 1dot Vertical Line |
2 | 2dot Vertical Line |
3 | 1dot Horizontal Line |
4 | 2dot Horizontal Line |
5 | Grid Vert (Grid Vert ical Line) |
6 | Grid Horizontal (Grid Horizontal Line) |
7 | Grid Pattern Small |
8 | Grid Pattern Large |
9 | Argyle Pattern Small |
10 | Argyle P:L (Argyle Pattern Large) |
11 | 1dot Ind. Pttrn (1dot Independent Pattern) |
12 | 2dot Ind. Pttrn (2dot Independent Pattern) |
13 | 4dot Ind. Pttrn (4dot Independent Pattern) |
14 | Trimming Area |
15 | Hounds tooth H |
16 | Hounds tooth V |
17 | Black Band H (Horizontal) |
18 | Black Band V (Vertical) |
19 | Checker Flag Pattern |
20 | Grayscale V (Vertical) |
21 | Grayscale H (Horizontal) |
22 | 2 Beam Density Pttrn |
23 | Full Dot Pattern |
24 | All White Pattern |