Ricoh D0BQ IMC6000
Error Message. Invalid Firmware
Cause
Corruption of the program files in the operation panel control chip.
• There is no damage to the hardware.
Solution
If the symptom occurs, do the following:
- Turn the machine main power OFF, and then remove the power cord from the outlet.
- Press the machine main power button.
• The blue LED (upper right) on the operation panel will light for a moment. - Reinsert the power cord into the outlet.
- Press the main power button while holding down the [EX1] and [EX3] keys.
• This is in order to access Recovery mode. - When the blue screen is displayed, hold down the [EX1] and [EX2] keys for four seconds.
- Once you enter Recovery mode,
• Press the [EX2] key four times, and then
• Move the cursor over to “Wipe free area partition”, and then
• Press the [EX3] key to execute the wipe of the free area partition. - Once the “Free area partition wipe complete” message is displayed in the lower left of the LCD
• Move the cursor over to “Reboot system now”, and then
• Press the [EX3] key to execute the reboot.