Ricoh D085 MP3351 R-C5.5

Procedure 1: Minor Adjustment of the Fusing Unit Height (front-to-rear)

1. Print out the SP2-902 Trimming Pattern (value: 10).
2. If the image is a pattern A trapezoid:
   a) Remove and reinstall the Fusing Unit.
   b) Tighten the left fixing screw while you push up the unit's left side (until it stops).
3. If the image is a pattern B trapezoid, do the same for the unit's right side.
4. If the image is still printed out as a trapezoid, do Procedure 2 below.

Procedure 2: Minor Adjustment of the Fusing Unit Position (front-to-rear)

1. Remove the fusing unit, then add a washer (t = 0.5 to 1.6) to the front fixing screw.
   • This will increase the distance from the mainframe stay.
2. Check the image.
   • Still NG: Go to the next step.
   • OK: Adjustment Complete.
3. Add more washers (t = 0.5 to 1.6, as above).
   • Too many washers can cause wrinkling in the paper.
   • Still NG: Go to the next step.
   • OK: Adjustment Complete.
4. Remove the fusing unit and all the washers added in steps 1 and 2 above.
5. Then, add washer(s) in the same way for the rear side.

Recommended Washers:

t = 0.5, 07080040Z or 07080040G
t = 0.8, 07080050Z or 07080050G