Lexmark 7562-432 X792de

Paper jam in the standard exit bin:

1. Firmly grasp the paper on each side, and then gently pull it out.
   Note: Make sure all paper fragments are removed.
2. From the operator panel, touch Continue, jam cleared.

Paper jam in the fuser:

1. Open the left access door.
2. Open the fuser access door.
3. Firmly grasp the jammed paper on each side, and then gently pull it out.
   Note: Make sure all paper fragments are removed.
4. Close the door.
5. From the operator panel, touch Continue, jam cleared.

Paper jam under the fuser:

1. Open the left access door.
2. If the paper is not visible, then remove the fuser unit.
3. Firmly grasp the jammed paper on each side, and then gently pull it out.
   Note: Make sure all paper fragments are removed.
4. Reinstall the fuser.
5. Close the door.
6. From the operator panel, touch Continue, jam cleared.

Additional checks—202–203 paper jams

Error code	Description	Action
202.01	Exit sensor is made when printer tries to print from an idle state. Possible causes: Damaged paper exit sensor or paper exit sensor flag Damaged fuser autoconnect Faulty fuser Faulty system board	Check for anything in the paper path that might cause the paper to jam. The fuser exit sensor may not be functioning properly. Go to “121.xx—Fuser error service check”.
202.02	Exit sensor is made early. Possible causes: Incorrect paper settings Defective exit sensor	Check for anything in the paper path that might cause the paper to jam. If clearing the jam does not solve the problem, go to “121.xx—Fuser error service check”.
202.03	Exit sensor is never made. Possible causes: Improper paper loading Paper wrapped in fuser Damaged paper exit sensor or paper exit sensor flag Damaged fuser autoconnect Faulty fuser DC cable connection Faulty fuser Faulty system board	Check for anything in the paper path that might cause the paper to jam. The fuser exit sensor may not be functioning properly. Go to “121.xx—Fuser error service check”.
202.04	Exit sensor broke early. Possible causes: Damaged paper exit sensor or paper exit sensor flag Faulty fuser Faulty system board	The fuser exit sensor may not be functioning properly. Go to “121.xx—Fuser error service check” .
202.05, 202.07	Exit sensor never broke. Possible causes: Damaged paper exit sensor or paper exit sensor flag Faulty fuser Faulty system board Faulty output bin flag	Check exit sensor flag on fuser for proper operation.Be sure the paper is not hanging on the flag. The fuser exit sensor may not be functioning properly. Go to “121.xx—Fuser error service check”.
202.08	Exit sensor is never made.	See “202.03” .
202.31	Bin-full sensor active when printing started. Possible causes: Paper jam leaving paper over the sensor Damaged bin-full sensor Faulty system board.	Clear away anything in the paper path that might cause the paper to jam. Be sure the paper settings match the media. Flex the media, and stack it flat in the tray. Properly set the paper guides in the paper tray. If the problem persists, go to “Pick arm stuck down service check”.
202.32	Bin-full sensor is made early. Possible causes: Incorrect paper settings Defective bin-full sensor	Check for anything in the paper path that might cause the paper to jam. If clearing the jam does not solve the problem, go to “202.32—Paper Jam error service check”.