Lexmark 7562-432 X792de

1. Open the side door.
2. Determine where the jam is located, and then remove it:
   a) If paper is inside the fuser, then open the fuser access door.
   b) Firmly grasp the jammed paper on each side, and then gently pull it out.
   Warning: Do not touch the center of the fuser unit. Doing so will damage the fuser.
   Note: Make sure all paper fragments are removed.
3. Close the side door.
4. From the operator panel, touch Continue, jam cleared.

Additional checks—201 paper jam

Error code	Description	Action
201.01	Bubble sensor active when printer powers up or a cover is closed. Possible causes: Paper jam leaving paper over the sensor Damaged bubble sensor Damaged fuser autoconnect Faulty fuser DC cable connection Faulty fuser Faulty system board	Clear away anything in the paper path that might cause the paper to jam. Be sure the paper settings match the media. Flex the media, and stack it flat in the tray. Properly set the paper guides in the paper tray. If the problem persists, go to ““Bubble sensor service check”.
201.02	Bubble sensor is made early. Possible causes: Incorrect paper settings Defective near narrow media sensor	Clear away anything in the paper path that might cause the paper to jam. Be sure the paper settings match the media. If clearing a paper jam does not fix the problem, replace the fuser. See “Fuser assembly removal”.
201.03	Bubble sensor is never made or is made late. Possible causes: Faulty bubble sensor Faulty fuser connection	Clear away anything in the paper path that might cause the paper to jam. If clearing a paper jam does not fix the problem, go to “201.03, 201.05, 201.07, 201.08—Paper Jam error service check”.
201.04	Bubble sensor broke early. Possible causes: Incorrect paper settings Defective bubble sensor Faulty system board	Clear away anything in the paper path that might cause the paper to jam. Be sure the paper settings match the media. Go to “121.xx—Fuser error service check”.
201.05, 201.07, 201.08	Bubble sensor is never made or is made late.	See “201.03” .
201.42	A narrow banner media error has occurred.	Clear away anything in the paper path that might cause the paper to jam. If clearing a paper jam does not fix the problem, go to “Input, S1, narrow media, and near narrow media sensor service check”.
201.51	Bubble sensor active when printer powers up or a cover is closed. (Fuser past life)	See “201.01” .
201.52	Bubble sensor is made early. (Fuser past life)	See “201.02” .
201.53	Bubble sensor is never made or is made late. (Fuser past life)	See “201.03” .
201.54	Bubble sensor broke early. (Fuser past life)	See “201.04” .
201.55, 201.57, 201.58	Bubble sensor is never made or is made late. (Fuser past life)	See “201.03” .