Kyocera ECOSYS P8060cdn

5. Fan rotating sounds are noisy

Fan motor is dirty or faulty.

Step	Check description	Assumed cause	Measures
1	Cleaning the fan motor	The fan of the fan motor is dirty.	Execute U037 and specify the fan motor which has a high rotation sound, and clean the fan.
2	Replacing the fan motor	The fan motor is faulty.	Reattach the fan motor and reconnect the connector. If not repaired, replace it.

6. Abnormal sound from the primary paper feed section

Frictional wear, smudges / foreign objects adhesion, attachment failure of the primary paper feed section

Step	Check description	Assumed cause	Measures
1	Checking the gear and the clutch	The parts such as the gear or the clutch are not properly attached.	Reattach the primary paper feed drive parts such as the gear or the clutch if they are not properly attached.
2	Cleaning and applying the grease	The gear or the bushing is dirty or foreign objects are on them.	Clean the gears and the bearings of the primary feed drive section, and apply the grease. (EM-50LP, Part number: 7BG010009H)
3	Cleaning and applying the grease	The shaft or the bushing is dirty or foreign objects are on them.	Clean the shaft and the bearings of the feed roller, and apply the grease. (EM-50LP, Part number: 7BG010009H)
4	Checking the paper feed roller	The paper feed roller surface is dirty or worn down.	Clean the paper feed roller, or replace it if necessary.

7. Abnormal sound from the machine front side

Wear, dirtiness, foreign objects adhesion or attachment failure at the MP feed section

Step	Check description	Assumed cause	Measures
1	Checking the gear and the clutch	The parts such as the gear or the clutch are not properly attached.	When the gears or the clutch in the MP paper feed drive section are not properly attached, reattach them.
2	Cleaning and applying the grease	The shaft or the bushing is dirty or foreign objects are on them.	Clean the shaft and the bearings of the MP feed roller, and apply the grease. (EM-50LP, Part number: 7BG010009H)
3	Checking the MP friction pad	The surface of the MP friction pad is dirty or worn out.	Clean the MP friction pad and replace it if necessary.
4	Checking the MP lift plate	The MP lift plate is not attached properly.	Reattach the MP lift plate.

8. Abnormal sound from the lower side than the fuser eject section

Rubbing sound between the bushing and the stop ring of the fuser eject roller due to the smudges / foreign objects adhesion

Step	Check description	Assumed cause	Measures
1	Cleaning and applying the grease	The fuser eject roller, bushing or the stop ring are dirty, or foreign objects are on them.	Clean the fuser exit roller, the bearings, stop ring, etc., and apply the heat resistant grease.
2	Replacing the fuser unit	The fuser unit is faulty.	Replace the fuser unit.

9. Abnormal sound from the upper side of the fuser eject section

Rubbing sound between the fuser exit sub roller and the shaft caused by the dirt or adhesion of the foreign objects.

Step	Check description	Assumed cause	Measures
1	Cleaning and applying the grease	The fuser exit sub roller or the bearings are dirty. Or, the foreign objects adhere.	Clean the fuser exit sub roller, the shaft, etc., and apply the heat resistant grease.
2	Replacing the fuser unit	The fuser unit is faulty.	Replace the fuser unit.