Kyocera ECOSYS P3150dn
Troubleshooting. Jam. Corrective Actions: J0511 - J0518
Jam types | Check description | Corrective measures |
---|---|---|
Multiple-feed Jam (J0511, J0512, J0513, J0514, J0515, J0519) | 1 Check if the cutting edge of the paper bundle is crumpled or the cassette is loaded with multiple times of replenishing paper. | If the cutting edge of the paper bundle is crumpled or the cassette is loaded with multiple times of replenishing paper, load new paper. |
2 Checking paper size. Check that the size of the loaded paper and the paper size chosen on the operator panel are met. | If the paper size does not agree. 1 If the cassette cursors are open against the paper, set it properly. 2 Insert the cassette until the cassette size detector switch is turned on. If the size is not detectable while automatic sizing is enabled, replace the size detection switch. |
|
If the paper size agrees 1 If paper other than complying the requirements such as coated paper, inkjet paper, etc., is used, replace the paper. 2 RE-assemble the retard roller in the primary paper feed unit if it is mounted to the oppisite direction. 3 Check if the retard spring has not been fallen off of the mounting position. • If the retard spring is not dropped off of the mount position, decrease the spring pressure that is applied to the separation rollers. 4 Replace the primary paper feed unit. |
||
3 Check if paper dusts and abrasion are observed on the paper fanning roller and retard roller. | If the paper fanning roller is dirty, clean. If abrasion is observed, replace. | |
4 Check the clutch that are rotating following the other component when the motor is turned on. | If the clutch rotates following the other component and its stain is observed, replace the clutch. | |
Duplex No-paper-feed Jam (J0508)/Duplex Multiple-feed Jam (J0518) | Check if the registration sensor is detected. | 1 Clean the sensor and paper dust on the opposite side. |
2 If the registration sensor is not working, replace the registration sensor. |