Konica-Minolta bizhub C3100P

STARTING PROCEDURE

1. Select [COUNTER] on the menu screen and press the Menu/Select key.
2. Press the following keys in this order.
   Cancel/Access -> down key -> down key -> Cancel/Access -> down key -> up key
3. Set first digit of password with the up key/down key and press the right key.
4. Repeat the above procedures to set up to eighth digit of password.
   Enter “92729272” for service password.
5. Press the Menu/Select key.

Exiting procedure

• Press the Cancel/Access key.

LIST OF SERVICE MODE

MACHINE	TEMPERATURE	PLAIN PAPER THICK 1 ENVELOPE
	ALIGNMENT	TOP ADJUSTMENT	PLAIN PAPER THICK THICK 2 ENVELOPE
		TOP ADJ DUPLEX	PLAIN PAPER THICK THICK 2
		LEFT ADJUSTMENT	LEFT ADJ TRAY1 LEFT ADJ TRAY2 LEFT ADJ MANUAL
		LEFT ADJ DUPLEX	LEFT ADJ TRAY1 LEFT ADJ TRAY2 LEFT ADJ MANUAL
		IMG ADJ THICK	CYAN MAGENTA YELLOW BLACK
		IMAGE ADJ PARAM
	LD ADJUSTMENT	LIGHT WIDTH
	FUSER CONTROL
	SCAN ADJUST VALUE	YELLOW MAGENTA CYAN
	MAIN SCAN PAGE
	AIDC MODE
	FINE LINE ADJ
	IU YIELD SETTING
	ACS
	UNIT CHANGE
	MODE CHOICE
	IMG ADJ BLACK
FIRMWARE VERSION	CONTROLLER F/W
	ENGINE F/W
	BOOT F/W
SYSTEM 1	INSTALL DATE
	MACHINE STATE LED	ALERT STATE
	TONER OUT MODE
	GRAYSCALE PAGE
SYSTEM 2	ENABLE WARNING	NEAR EMPTY	TONER CARTRIGE IMAGING UNIT LOW WASTE TONER BOX
		NEAR EMPTY CHOICE
	SOFT SWITCH
	MEDIA ADJUSTMENT	FIRST SIDE SECOND SIDE
	AIDC PROCESS
	TE CLEAR
	CARIBRATION
	COVERAGE
COUNTER	LIFE	REPLACE	FUSER UNIT
			TRANS. BELT
			TRANS. ROLLER
PRINT MENU	MANAGEMENT LIST
	HALFTONE 64	CYAN 64 MAGENTA 64 YELLOW 64 BLACK 64
	HALFTONE 128	CYAN 128
		MAGENTA 128
		YELLOW 128
		BLACK 128
	HALFTONE 256	CYAN 256
		MAGENTA 256
		YELLOW 256
		BLACK 256
	GRADATION
STATE	SENSOR CHECK
	COMPONENT CHECK
BK CLEAR
FIRMWARE UPDATE *1
LOADABLE DRV.
LOADABLE DOWNLOAD *1
HDD FORMAT
ENGINE DIPSW

*1: It will be displayed only when a USB memory device is installed.
*2: It will be displayed only when a HDD is installed.