Konica-Minolta bizhub C300i
Firmware 3. USB memory. Updating
Starting the update screen
NOTE
- When [Administrator] -> [Security] -> [USB port connection permission] -> [USB flash drive] -> [Firmware Update Parameters] is set to "Restrict", firmware update cannot be executed by using a USB memory.
- When the main power switch is turned on, a message "It is limited by the administrator." will appear.
- When [Administrator] -> [Security] -> [Firmware Update (USB) Permission Setting] is set to "Password Priority", it requires to input a password after confirming with the administrator.
- USB memory must be connected with the main power switch off.
Procedure
- Turn OFF the main power switch.
- Connect the USB memory containing the firmware into the USB port on the right side of the control panel.
- Remove the cover [1] at the back of the control panel.
- Turn the main power switch ON while pressing the [Rear Stop] key [2].
- Firmware Update selection screen is displayed.
NOTE
- Unless one of the keys on the control panel is pressed, firmware is automatically updated after 30 seconds when the main power switch is turned on.
- Selectable items displayed change depending on equipped options, etc.
Selecting the firmware data
- When multiple set of firmware data is stored in the USB memory, a set of data can be selected.
- The firmware data in the update data folder "FW0020" copied to the root directory of the USB memory is selected as the default data.
Procedure
- Touch [FW Data Select] on the firmware update selection screen.
- After the data in the USB memory is checked, a list of the available firmware data is displayed.
• The default data is indicated by an asterisk (*). - Select the firmware, and touch [OK].
Language Selection
- Select the language data displayed on the Language Selection screen of Utility.
- Select languages as required according to, for example, the use environment of the user.
NOTE:
Up to 9 languages are selectable. However, Japanese and English are essential options.
Procedure
- Touch [Language Select] on the firmware update selection screen.
- On the Language Select screen, select a language to be displayed on the LCD area of the control panel, then touch [Fix].
- Touch [OK].
Updating the firmware
- Select the target firmware data to be updated in the Firmware Update selection screen. If multiple pages is displayed in the selection screen, check all of the pages.
- Press the [START]. (At this time, the Power key LED starts blinking red.)
NOTE
▪ The progress ratio of each board is displayed in writing the program. - Check that the control panel shows the message indicating that the data has been rewritten correctly ([Downloading Completed]). (The
Power key LED lights blue.)
NOTE
▪ Check all pages, and make sure that no item is under firmware updating (Downloading...). - Turn OFF the main power switch.
- Remove the USB memory.
- Turn ON the main power switch.
- Check the firmware version in Service Mode.