Konica-Minolta bizhub C227
Troubleshooting. Jam Codes: 10-01, 10-02, 10-40
Contents
| JAM type | Misfeed at manual bypass feed section |
| JAM code | 10-01, 10-02, 10-40 |
| JAM detection timing | 10-01 The leading edge of the paper is not turned ON (unblocked) the registration sensor (PS1) even after the lapse of a given period of time after the manual bypass tray starts to feed paper. |
| 10-02 For paper fed from the manual bypass tray, loop forming has not been complete before a sheet enters the registration roller because the rise timing of load to perform registration is earlier than the rise timing of load to form a loop. |
|
| 10-40 For paper fed from the manual bypass tray, the image write start signal permit continues to be disabled for a predetermined period of time after the timing of the image write start signal output. |
|
| Misfeed processing location | Right door |
| Relevant parts | • Transport motor (M1) • Registration clutch (CL4) • Bypass paper feed clutch (CL7) • Registration sensor (PS1) • MFP board (MFPB) |
Procedure
| Step | Action | Control signal | Location |
|---|---|---|---|
| 1 | Initial check items | ||
| 2 | PS1 I/O check, sensor check | MFPB CN13E<A>-9 (ON) | 7-C |
| 3 | CL4 operation check | MFPB CN13E<A>-11 (ON) | 7-C |
| 4 | CL7 operation check | MFPB CN30E-2 (ON) | 13-C |
| 5 | M1 operation check | MFPB CN11E-4 (REM) MFPB CN11E-7 (LOCK) |
3-C |
| 6 | MFPB F13E, F21E conduction check | ||
| 7 | Replace MFPB. |