Konica-Minolta bizhub 4700P
Service Mode. Diagnostics menu. Base Sensor Test
Use the Base sensor test to verify that the sensors located inside the printer are working correctly.
The following sensors can be checked using this test:
• Input
• Exit
• Narrow Media
• Front Door
CAUTION—SHOCK HAZARD: The sensor may be electrically energized. To avoid the risk of injury use a non-conductive implement to toggle the sensors.
To run the Base sensor test:
- From the Diagnostics menu, navigate to Base Sensor Test.
- Choose a sensor.
- Manually actuate the sensor to verify that it toggles. If the sensor does not toggle, then it is malfunctioning.
Sensor Values Input
Exit
Front DoorOpen
ClosedNarrow Media Narrow
Wide - Press ✖ to exit the test.