Konica-Minolta bizhub 3602P
Maintenance schedule
Inspection guide
The purpose of this inspection guide is to aid you in identifying the intervals, based on page count, at which parts must be inspected (for visible physical damage), cleaned, or replaced.
If any unsafe conditions exist, find out how serious the hazard could be and if you can continue before you correct the hazard.
As you service the machine, check for the following:
- Damaged, missing, or altered parts, especially in the area of the On/Off switch and the power supply
- Damaged, missing, or altered covers, especially in the area of the top cover and the power supply cover
- Possible safety exposure from any non-KONICA MINOLTA attachments
Use the following table to determine when specified parts should be inspected:
PART | EVERY SERVICE CALL | EVERY 200K |
---|---|---|
Fuser | Inspect | Replace |
MPF pick roller and separator pad | Inspect | Replace |
Pick tires | Inspect | Replace |
Transfer roller | Inspect | Replace |
Separator roller assembly (bizhub 4702P only) | Inspect | Replace |
Scheduled maintenance
The control panel displays an 80.xy error when it reaches 200K page counts. It is necessary to install the appropriate Maintenance parts to maintain the print quality and reliability of the printer. Reset the maintenance counter after replacing the Maintenance parts.
Maintenance parts
When performing the 200K scheduled maintenance procedure, the following areas should be cleaned of media dust and toner contamination:
- Media trays
- Imaging unit area
- Transfer roller area
- Duplex area
- Standard bin
Resetting the maintenance counter
Always reset the maintenance counter after installing the Maintenance parts.
To reset the maintenance counter:
- POR into the Configuration menu, and navigate to Reset Maintenance Counter.
- Depending on the printer model, press OK to reset the counter, or press X to exit without resetting the counter.
Once initiated, the operation cannot be canceled.