Epson WorkForce WF-C8190a
Service mode. Startup and operating procedures WF-C8690/ C8690A/ C8610
Overview
Service support mode is a service dedicated special mode that can be started by a special operation, and allows you to execute functions including adjustment, inspection, and individual operation check functions.
WF-C8690/C8690A/C8610 STARTING METHOD
- Press and hold down the power button while pressing the [#] button from the power-off state until a message appears on the panel LCD.
ID number input screenUP: [2] / DOWN: [8]]
SHIFT: [6] / Fin : [#]
_
- Enter ID number of Service Support Mode, and start the service support mode.
Enter "89109" when starting service support mode
ID number input screenUP: [2] / DOWN: [8]]
SHIFT: [6] / Fin : [#]
***_
Operating procedure
• Number input (move in ascending order) : [2] button
• Number input (move in descending order) : [8] button
• Input digit shift : [6] button
• Execute : [#] button
ID number input procedure
- Press a number input button ([2] button or [8] button) to enter a number from 1 to 9.
- Press the input digit shift button ([6] button) to shift to the next digit.
▪ It is not possible to return to the previous digit after shifting digits. If you wish to correct the number of the previous digit, proceed with the steps until after step 5 and then perform input again.
▪ Please note that the execute button is not enabled until at least two digits have been entered. - Press a number input button ([2] button or [8] button) to enter a number from 1 to 9.
- Repeat the above procedure to enter the specified ID number.
- When all of the ID number is entered, press the execute button ([#] button). (A confirmation message appears.)
- Press the execute button ([#] button) to execute or press the input digit shift button ([6] button) to enter the number again.
Service Support Mode Screen
Service Support Mode Top
Up/Down:[2][8] Shift:[4][6]
Back:[*] Run:[#]
Individual Action Check: MENU
Before Repair Operation:MENU
Adjustment:MENU
Maintenance:MENU
Swap Mech Unit:MENU
USB FWUpdate
CR Unlock Power Off
User Log Get Mode
Debug Log Get Mode:MENU
Counter Reset
Up/Down:[2][8] Shift:[4][6]
Back:[*] Run:[#]
Individual Action Check: MENU
Before Repair Operation:MENU
Adjustment:MENU
Maintenance:MENU
Swap Mech Unit:MENU
USB FWUpdate
CR Unlock Power Off
User Log Get Mode
Debug Log Get Mode:MENU
Counter Reset