Canon imageRUNNER Advance C5045i
Troubleshooting. Jam Code. Main Unit 1
Main Unit
ACC ID | Jam Code | Type | Sensor Name | Sensor ID |
---|---|---|---|---|
00 | 0B00 | Door open | Front door sensor,Right lower door sensor,Right door sensor | PS18,PS19,PS20 |
00 | 0B90 | Door open | Front door sensor,Right lower door sensor,Right door sensor | PS18,PS19,PS20 |
00 | 0105 | Delay jam | Registration sensor | PS33 |
00 | 0205 | Stationary jam | Registration sensor | PS33 |
00 | 0A05 | POWER ON | Registration sensor | PS33 |
00 | FF05 | Sequence jam *2 | Registration sensor | PS33 |
00 | 0106 | Delay jam | Fixing inlet sensor | PS34 |
00 | 0206 | Stationary jam | Fixing inlet sensor | PS34 |
00 | 0A06 | POWER ON | Fixing inlet sensor | PS34 |
00 | FF06 | Sequence jam *2 | Fixing inlet sensor | PS34 |
00 | 0107 | Delay jam | Inner delivery sensor | PS37 |
00 | 0207 | Stationary jam | Inner delivery sensor | PS37 |
00 | 0A07 | POWER ON | Inner delivery sensor | PS37 |
00 | FF07 | Sequence jam *2 | Inner delivery sensor | PS37 |
00 | 010D | Delay jam | Duplex paper sensor | PS38 |
00 | 020D | Stationary jam | Duplex paper sensor | PS38 |
00 | 0A0D | POWER ON | Duplex paper sensor | PS38 |
00 | FF0D | Sequence jam *2 | Duplex paper sensor | PS38 |
00 | 010A | Delay jam | Reverse sensor | PS39 |
00 | 020A | Stationary jam | Reverse sensor | PS39 |
00 | 0A0A | POWER ON | Reverse sensor | PS39 |
00 | FF0A | Sequence jam *2 | Reverse sensor | PS39 |
00 | 010C | Delay jam | Duplex inlet sensor | PS40 |
00 | 020C | Stationary jam | Duplex inlet sensor | PS40 |
00 | 0A0C | POWER ON | Duplex inlet sensor | PS40 |
00 | FF0C | Sequence jam *2 | Duplex inlet sensor | PS40 |
*1 The state is recovered by opening and closing the Door, or turning OFF and then ON the power supply. If the same jam is detected regardless of the operation above, the error code is displayed.
*2: The state is recovered by opening and closing the Door, or turning OFF and then ON the power supply. If it is not recovered by the above operation, it is considered an error near the target sensor. Disconnect and then connect the connectors around the target sensor, check if the cable is open circuit, and replace the sensor.
*3: The state is recovered by opening and closing the Door, or turning OFF and then ON the power supply. If it is not recovered by the above operation, operation failure of the Finisher (including error in the harness) is suspected as a cause.