Canon imageRUNNER Advance C356iF III
Adjustment. Original Exposure System
Right angle adjustment
Place a test chart on the ADF and make a copy. Then measure A and B dimensions of the leading edge of paper. If the skew amount is not within the standard, perform this adjustment.
• Standard value: A - B = 0 +/- 1.5 mm
- Loosen the 4 Right Hinge Fixation Screws and make the adjustment by moving the hinge installation position back and forth.
- Place a test chart on the ADF again and make a copy again.
- Repeat the steps 1 to 2 until the skew amount falls within the specified value.
- When the skew amount is within the range, tighten the Fixation Screws you loosened.