Canon iR1133A

ADJ-X

Adj of img pstn in book mode: vert scan

Details	To adjust the image reading start position (image leading edge position) in the vertical scanning direction at copyboard reading. When replacing the Main Controller PCB/clearing the RAM data, enter the value of service label. When the non-image width is larger than the standard value, set the smaller value. When out of original area is copied, set the larger value. As the value is incremented by 1, the image position moves to the trailing edge side by 0.1 mm.
Use case	• When replacing the Reader Unit • When replacing the CIS Unit • When replacing the Main Controller PCB
Adj/set/operate method	Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Caution	After the setting value is changed, write the changed value in the service label
Display/adj/set range	-30 to 30
Unit	0.1 mm
Default value	0

ADJ-Y

Adj of img pstn in book mode: horz scan

Details	To adjust the image reading start position in the horizontal scanning direction at copyboard reading. When replacing the Engine Controller PCB/clearing the RAM data, enter the value of service label. When the non-image width is larger than the standard value, set the smaller value. When out of original area is copied, set the larger value. As the value is incremented by 1, the image position moves to the rear side by 0.1 mm.
Use case	• When replacing the Reader Unit • When replacing the CIS Unit • When replacing the Main Controller PCB
Adj/set/operate method	Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Caution	After the setting value is changed, write the changed value in the service label.
Display/adj/set range	-10 to 10
Unit	0.1 mm
Default value	0